Havis-Shields C-AS-1025 Manuel d'utilisateur télécharger pdf

ANGLED SERIES CONSOLES

INSTALLATION INSTRUCTIONS

Models C-AS-1060, 1025, 1325, 1525 & 1725

TOOLS REQUIRED:

Standard and Metric socket set with 6”extension.

Standard and Metric wrench set

#20 and #15 Torx driver

TRAK MOUNTED CONSOLE

HARDWARE:

QTY: DESCRIPTION: PART #:

8 ¼-20 X ¾”Hex Head Bolt GSM33001

8 ¼” Flat Washer GSM31005

6 ¼” Lock Washer GSM31026

8 ¼-20 Hex Nut GSM30005

INSTALLATION:

1. Remove inner front seat mounting bolts near transmission

hump. Just loosen outboard bolts.

2. Place ¼ - 20 x ¾” Hex head bolts into under side tracks of

trak mount.

3. Position trak mount in desired location before tightening

down hump mount.

4. Mount rear hump brackets to under side of trak.

5. Place trak with positioned hump mount brackets over

transmission hump and onto front and rear seat mount

studs. Place seat bracket on top of hump mount brackets

and replace seat mount bolts.

6. Slide console up to dash and secure to trak mount with 1/4”

hardware.

7. Unit is ready to accept equipment control heads.

5 6

2/3

1 2

ANGLED SERIES CONSOLES INSTALLATION INSTRUCTIONS Models C-AS-1060, 1025, 1325, 1525 & 1725 TOOLS REQUIRED: Standard and Metric socket set with 6

C-AS-INST-11-06 HUMP BRACKET MOUNTED CONSOLE HARDWARE: QTY: DESCRIPTION: PART #: 4 ¼-20 x ¾” Carriage bolt GSM32000 4 1/4” Flat Nylon Reta

Pas de commentaire

Havis-Shields C-AS-1025 Manuel d'utilisateur